Dry spray wall for spraying tasks
- Fully developed paint mist extraction wall with dry separation
- Solid, compact construction with low installation depth
- Highly effective separation by three-stage filtration of paint mist
- Low-cost cardboard filter mats for easy replacement
- Operational reliability due to high quality of each individual component
Questions
on this product?
Description
The FarbMax paint mist extraction wall is the perfect paint system for small rooms and workshops. With a solid, compact construction and a low installation depth of a mere 800 mm it can be installed directly on the wall to save space. The extraction wall has a positioning system enabling it to be placed wherever it is needed.
The parts to be painted should be positioned in front of the extraction wall to allow overspray to be collected by the extraction system. It hits the front cardboard filter mat in the first stage. Paint particles enter the retention pockets of these filters, accumulate there and cure. In the next two stages additional particles remaining in the airstream are filtered out through a non-woven fibreglass and a fine filter.
Stripped of solids, the clean exhaust air is blown through the wall or ceiling to the surroundings via an exhaust system. The room in which the extraction wall is installed must be supplied with sufficient new fresh air due to the negative pressure produced by the extraction process. Supply air systems equipped with heat exchangers can be installed if required. These systems transfer the heat from the exhaust air to the new fresh air and can yield substantial heating cost savings in the winter.
The easy access to this spray wall makes changing of the economical filter mats fast and trouble-free. Drip pans additionally catch the paint mist and keep the workshop floor clean.
Other advantages
- Effective extraction with integrated underfloor extraction
- Large filter surface area with optimal separation efficiency for paint particles
- Low-cost filters and easy filter change
- Positioning system for mobile use in the workshop
- Low acquisition costs
- Space-saving, solid construction
- Energy-saving operation
- Low maintenance requirements
- Simple and quick assembly
Installation & items delivered
For transport reasons the FarbMax is delivered as separate components. It can be assembled quickly with the help of the supplied easy-to-follow assembly instructions.
Items delivered:
- Paint mist extraction table with attached extractor fan, explosion-proof in accordance with VDMA 24 189 Part 1, motor PTB-tested
- Front filter mat (deflector surface) made from VHC cardboard filter (flame-retardant)
- Inner filter mat 1 (green paint stop) on the horizontal suction pipe
- Inner filter mat 2 (particulate matter filter mat F5) on the horizontal suction pipe
- 2 pcs Push-in floor filter mats
- Connection cable of length 10.0 m with a CEE type 16-6 h Nolta motor protection plug which is also the on/off switch (the socket must be situated outside the hazardous area!)
Technical data
Downloads
The following products might also interest you:
Questions on a particular product?
Call our product advisor on 0049 7581 4871 0 or use the form below. A Schuko employee will only visit you if you explicitly require it and have indicated this above.